HC-Industry Pellets Cooler mainly consists of cooling chamber, feeder, discharging system, vibrating screen, cyclone, air-blower, air-lock, etc. While the cooler starts to work, the high temperature pellets enter into the storage bin and distribute evenly in the cooling chamber. The cold air passes through the hot pellets vertically from the bottom to the top of cooler.(which is opposite to the direction of pellets entering.)
The cold air contacts with the pellets and gradually takes away more heat and humidity on them. The air-blower takes the hot air and dust out of the cooling chamber.
After finish the cooling process, the discharge system will work and drop cool pellets. The pellets dropping from the discharge device should be shaked by vibrating screen to get dust and unqualified pellets away, and the qualified pellets can be directly packed and weighed.

1. Low energy consumption. In the counter-flow cooler, the cool air passes through material layer in vertical direction from the bottom. The newly absorbed air firstly touches cold pellet at the bottom and then hot pellet on the top through material pole. In the end, the temperature of the air coolant discharged almost equals its temperature at the feed opening, that is to say, the air can carry out the most heat quantity. It needs a small amount of air coolant, so the blower fan with less power can be use.
2. Uniform cooling. Because the air coolant enters from the bottom of the whole cooler, rises through material layers slowly and evenly and then is discharged, there is little temperature difference in the same material layer.
3. Good quality of Pellets. Pellets contact with the cool air which enters from the bottom shall be cooled down. The air is heated slowly while rising, and when it arrives on the top, it touches hot air heated beforehand, i.e. the temperature difference between all pellets layers and the air coolant decreases lest, avoiding such damages as cracks and cracking caused by shock cooling, which improves the quality of finished pellets.
4. No condensation or dew. In the counter-flow cooler, because the air is heated intensively and the air temperature is kept over the moistening point in the cooling procedure, the dew won’t appear.

1. Low energy consumption.
2. High cooling efficiency and capacity.
3. Uniform cooling.
4. Low damage rate during cooling process.
5. No condensation or dew.
6. Temperature of cooled pellets is not higher than room temperature 3-5℃.
7. CE approved by SGS.

Model	Main Power (kw)	Cooling Volume (m3)	Capacity (t/h)	Power of air-blower (kw)	Dia. Cyclone (mm)
HC-C1.5	0.75+0.55	1.5	1-1.5	5.5	800
HC-C3	0.75+0.55	3	1.5-3	5.5	1000
HC-C4	1.1+0.75	4	3-5	7.5	1000
HC-C6	1.5+1.1	6	5-12	15	1200
HC-C8	1.5+1.5	8	12-16	22	1500